How to install decorative lights code 160

Required tools:
1. Lamp and accessories
2. Drill and drill bit size 7
3. Screwdriver and Allen wrench
4. Screws and roll of license plates

How to install:
1. Using an Allen wrench, unscrew the side screws on the product.
2. Make sure that the two washers included in the product are installed behind the support to keep it away from the surface and prevent water from entering the product.
3. Make sure that the silicone washer is in the correct place because the product is waterproof. Use a cutter to make a groove on it so that the wire can pass through it.
4. Mark the hole on the support on the desired surface and close it with a drill, screws, and a roll of wall plugs.
5. Connect the input phase and neutral to the product terminal.
6. Use an Allen wrench to fasten the side screws on the product to the support.