Instructions for installing decorative lights code 123/1 and 123/2

Required tools:
1. Lamp and accessories
2. Drill and drill bit size 7
3. Screwdriver and Allen wrench
4. Screws and roll of license plates

How to install:
1. Using an Allen wrench, unscrew the side screws of the product to separate it from the support.
2. Make sure that the silicone gasket is in the correct place because the product is waterproof. Use a cutter to make a groove on it so that the wire can pass through it.
3. Mark the hole on the support on the desired surface and close it with a drill, screws, and a flat plate on the surface.
(Make sure that the gasket around the support is in the correct place)
4. Connect the phase and neutral input to the product
5. Using an Allen wrench, fasten the side screws of the product to the support.