Instructions for installing decorative lights code 153, 154 and 155

Required tools:
1. Lamp and accessories
2. Drill and drill bit size 7
3. Screwdriver and Allen wrench
4. Screws and roll of license plates

How to install:
1. Using an Allen wrench, unscrew the side screws on the product.
(Make sure that the silicone gasket is in the correct place because the product is waterproof. Use a cutter to make a groove on it so that the wire can pass through it)
2. Mark the hole on the support on the desired surface and close it on the surface with a drill, screws and a roll of plate.
3. Make sure that the two washers included in the product are installed behind the support to keep it away from the surface and prevent water from entering the product.
4. Connect the phase and neutral input to the product terminal
5. Using an Allen wrench, fasten the side screws on the product to the support