Instructions for installing decorative lights code 175 and 178 – 10 watts

Required tools:
1. Lamp and accessories
2. Drill and bit size 7
3. Allen wrench size 2.5
4. Screws and license plate roll

Installation method:
Due to the waterproof nature of the product, the cable behind the lamp should not be brought inside, and the phase and neutral wires of the work surface should not be brought inside the lamp, otherwise water will penetrate into the lamp and the warranty will be void.
1. Using a size 2.5 Allen wrench, we unscrew the two screws on the product.
2. Mark the two screw locations on the support on the desired surface and fasten them on the desired surface with a drill and a 7-inch drill and screws and a flat washer.
3. Make sure that the silicone gasket is in the correct place.
4. The lamp door is connected to the body with two Allen screws at the top and bottom.
Note: The screw locations on the support of this product are the same as those of the 112 and 110 lamps.